Quick Start - Basic Operation
Introduction
The MBT 250 systems are very easy to operate. As received from the factory, the system can be quickly set up for
use in standard soldering/desoldering operations. Simply perform the following Quick Start Procedure to begin
system operation.
Quick Start Procedure
1.
Insure that the Set-Up procedure has been performed; check for the following:
a)
VisiFilter connection to the AUTO SNAP-VAC Port on the front panel of the power source.
b)
Handpiece cable and air hose connections to the power source.
NOTE
If more than one air-operated handpiece (SX-80, TJ-70, TP-65 or DTP-80) is
connected to the power source, insure that only one of the Air Hoses is connected
to either the VisiFilter assembly (connected to the AUTO SNAP-VAC Port) or the
Controllable PRESSURE Port. Attachment to both simultaneously will cause a
deterioration in performance.
a)
All handpiece Tip & Tool Stands set up as desired (using instructions enclosed).
b)
Proper tips installed in handpieces.
c)
Power cord connection between the house AC supply receptacle and the power source.
2.
Turn the Power Switch "On" ("l").
Figure 12. Power On
24
