84
DISPENSING MATERIAL
The operator may select the
Continuous
(
CONT
) or
TIMED
Mode of operation.
The
CONT
Mode allows the operator to dispense the material for as long as the foot pedal remains
depressed. The
TIMED
/
CONT
Switch must be placed in the
CONT
position for use in this mode. This
mode is recommended for use when dispensing a continuous bead of material.
The
TIMED
Mode allows the operator to select a dispense time of 0.1 to 10 seconds as determined by the
PASTE
(
DISP
) Timer Control. The
TIMED
/
CONT
Switch must be placed in the
TIMED
position for use in
this mode. Use of this mode is recommended for all dot dispensing applications.
Follow the procedure below to obtain proper results.
1. Insure that the proper material and tip have been
installed.
2. Set the
TIMED
/
CONT
Switch for the mode of operation
desired. Set the switch to
CONT
for continuous
operation or
TIMED
for timed operation.
3. If in the
TIMED
Mode, set the
PASTE
(
DISP
) Timer
Control to the desired dispense time period.
Figure 105. Timed/Cont Switch
Figure 106. Paste Disp Timer
Summary of Contents for PRC 2000
