6
RNG110 OPERATOR’S MANUAL (501-3438000)
REAR PANEL
COMPONENT VIDEO
Component video output for
analog
HDTV
AUDIO OUT
Audio outputs
(stereo, R and L)
CABLE IN
From cable
service-provider
VIDEO OUT
Composite video
output
DC IN +5V
power input
(Make this
connection
last of all)
OPTICAL
AUDIO OUT
Optical S/PDIF
audio output
ETHERNET
For future use
HDMI
TM
Video and audio
output for
digital
HDTV
USB (Universal Serial Bus)
port
To connect USB devices (future use)
IR RECEIVE
Infra-red input from
a remote “eye”
1394
For connection to a
1394-compatible device
Separable security module
(behind side-panel cover)
Removal will interrupt your service
CABLE IN
Connect the cable service here.
ETHERNET
For future use.
1394
Connect to a 1394-compatible device.
IR RECEIVE
Connect to an optional remote “eye”.
VIDEO OUT
Connect to the composite video input on your VCR (or a standard TV).
AUDIO OUT
Connect to the R and L audio inputs on your stereo TV, stereo VCR, or
optional stereo amplifier.
COMPONENT
VIDEO
If your HDTV does not have an HDMI, connect your HDTV here.
OPTICAL AUDIO OUT
Connect to the
optical
digital audio input on optional digital audio
equipment.
HDMI
(High Definition
Multimedia Interface)
If your HDTV has an HDMI, connect it here for a
digital
audio/video
connection (instead of using the AUDIO and three
analog
COMPONENT
VIDEO connectors).
USB
(Universal Serial Bus) port
Connect to compatible optional equipment that supports a USB 2.0
interface (future use).
Separable security module
(behind side-panel cover)
Removal will interrupt your service.
DC IN +5V
power input
Connect your set-top’s power cord here.
Make this connection last of all.
NOTE
Copy protection via an HDMI
secure link
The HDMI link between your set-
top and your HDTV should be a
secure link. When your set-top is
attached via an HDMI cable to an
HDCP-compliant (High-bandwidth
Digital Content Protection) HDTV,
the HDTV and set-top negotiate a
secure link, which allows your set-
top to transmit full resolution video
(picture) to your HDTV.
Not all HDTVs support HDCP. If
your set-top is connected to an
HDTV that does not support it, the
following may be displayed:
Your HDTV does not support HDCP.
Please use the YPbPr component
connection to watch TV.
The HDMI output is then disabled,
so no picture is transmitted from
this connector. In that case, use
the component video connectors to
connect up (see Setup B).
