22
RNG150N / RNG200N USER GUIDE (501-3339201) B949/B950
MAKING USER SETTINGS (cont.)
Restoring the factory default settings
If you wish, you can restore the user settings and subtitle settings to their factory defaults. All the changes you
have made will be lost and the settings will revert to those that were programmed in the factory. The factory
settings are:
PACE USER/SUBTITLE SETTINGS
menu item
Options
Factory default setting
TV Aspect Ratio
–
16:9
TV Display Capability
1080i
720p
480p
480i
1080p24 Pass
1080p30 Pass
1080p60
Yes
No
Yes
Yes
No
No
No
Auto Pillarbox
–
No
Closed Captions
–
Off
Configure Captions
Various
All Auto except Hi Def CC, which
is Service 1
Front Panel Settings
Standby Brightness
Viewing TV Brightness
Std
High
HDMI Settings
Audio Output Mode
Disable Auto Detect
Auto
No
Language Settings
English
Espagñol
Français
Português
English
Subtitles
–
Off
Subtitle Language
–
English
If you have not done so already, put your set-top into User Settings mode, as described on page 15.
1. Press the
D
button on your remote control until the front panel shows “reSt” (short for “
rest
ore factory
settings”) and Restore Defaults is highlighted on the PACE USER SETTINGS menu.
2. Press the
R
button.
“YeS” appears on your set-top’s front panel and the message: “Restore Defaults. Press OK to confirm”
appears on your TV screen. (If, at this stage, you no longer wish to restore the factory settings, press the
L
button.)
3. To confirm and restore the factory settings, press the
OK/Select
button.
The factory settings are restored, and the PACE USER SETTINGS menu reappears.
4. If you want to continue changing the settings, see the sections from page 15 onwards. If you have finished
changing the settings, press the
POWER
button on your remote control. Your set-top then switches on
with the restored settings.
NOTE
If your set-top and HDTV are
connected via a standard HDMI
cable, your HDTV may pass
information about the required
settings back to your set-top (see
page 15). If you wish to restore
your set-top’s settings to those
created by your HDTV, you must
disconnect the HDMI cable from
your set-top before you restore the
factory default settings. When you
reconnect your HDTV to your set-
top via the HDMI cable, your HDTV
will pass back the information
again.
Always turn off your set-top, wait
60 seconds, then disconnect your
set-top’s power supply unit from
the wall AC outlet before you
connect or disconnect any other
equipment to or from its rear
panel.
Restore Defaults
Press OK to confirm.
