SX-80
SX-80
SX-80
SX-80
SX-80
3
Introduction
The SX-80 Sodr-X-Tractor handpiece provides thermally enhanced through-hole
desoldering on extra heavy multilayer assemblies at safer, lower temperatures, even
during continuous use. It features a large, easy to replace solder trap. The SX-80
also provides safe removal of TQFP (Thin Quad FlatPack) and TSOP (Thin Small
Outline Package) surface mount components and continuous removal of old solder
from surface mount lands. Its slim-line, pencil grip design and finger actuated
vacuum switch facilitates ease of use and manipulation in tight places. The SX-80 is
a member of the PACE SensaTemp family of advanced handpieces.
CAUTION
Always return heated handpieces to the appropriate Tip & Tool Stand when not in
use. Failure to do so may cause burns to the operator, equipment or work surfaces
and may be a potential ignition source if combustible materials are nearby. Always
use this handpiece in a well ventilated area to avoid inhalation of fumes created by
solder flux.
NOTE
Always use your SX-80 Sodr-X-Tractor with a clean VisiFilter (See page 6) element.
Otherwise a deterioration in performance or damage to the unit may occur.
Select and enter your desired true operating temperature on your PACE power source.
To save tip life and reduce the possibility of damage, PACE recommends using the
lowest possible tip temperature that will provide rapid yet controllable melt of the
entire solder joint to be extracted. Begin with an operating temperature in the range
of 316°C (600°F) and adjust as necessary.
SX-80
Sodr-X-Tractor Handpiece
Part Number 6010-0106
Manual Number 5050-0492
Rev. C
The following instructions detail the basic operational guidelines for using the
SX-80 Sodr-X-Tractor handpiece.
