PACE Sodr-X-Tractor Handpiece
©2008 PACE Inc., Southern Pines, NC. All Rights Reserved
Page 9 of 11
www.paceworldwide.com
Heater Replacement
The Sodr-X-Tractor utilizes a modular heater design, which allows for a quick and easy change out of the heater
assembly.
1. Remove and set aside any installed tip from the handpiece.
2. Disconnect the handpiece from the receptacle of the power source.
3. Remove the two heater assembly screws. These screws can be accessed through the two holes found on the
face of the heater shroud.
4. After the two heater assembly screws have been removed and set aside, remove the heater assembly by
pulling the heater module straight out.
5. Reassemble the handpiece in the following order.
6. Align the modular heater plug with receptacle on the handle assembly and gently push into place.
7. Replace and tighten the two heater assembly screws. Insuring that the heater assembly is snugly in place
when through. Be careful not to over tighten the screws.
8. Connect the handpiece to the power source and return the handpiece to the cubby or resume work.
NOTE:
There are two heaters available for the SX80/90 handpieces. If your handpiece
came with a heater with a
black
plug-in connector you must order and use heater
part number 6010-0107-P1, if your handpiece came with a heater with a
Blue
plug-in
connector you must order and use heater part number 6010-0163-P1. A heater with
the blue connector will NOT fit in to a handpiece fitted with the black connector.
Corrective Maintenance
Your Sodr-X-Tractor requires no special maintenance other than being kept clean. The heater bore and the heater assembly
set screw, which secures the tip, must be kept free of oxidation and debris in order to maintain the proper tip-to-ground
resistance.
