6
SAFETY INFORMATION (cont.)
Safety aspects of connections
Full details of the rear panel are on pages 8 and 9.
Connecting
Do not connect your set-top box (or any other equipment such as a TV or VCR)
to the power supply until you have properly connected all the other cables.
Your set-top box is designed for use only with the power supply unit provided.
On the power supply unit there is a label that specifies the correct AC power
supply input for it. Do not connect the power supply unit to any supply other
than this.
Always connect the 15 volt DC cord from the power supply unit to your
set-top box before you insert the AC power cord from the power supply unit
into the wall AC outlet.
Disconnecting
To disconnect power from your set-top box, always detach the power supply
unit from the wall AC outlet (rather than remove the 15 volt cord from your
set-top box).
Therefore you must install your set-top box near to the wall AC outlet, which
should be easily accessible.
If you are in any doubt about the power supply cord, its plug or its
connection, or are not certain that the electrical outlets you are using
are properly wired and grounded, consult a qualified electrician before
proceeding any further.
The
CABLE IN
connector is designed
for connection to a cable network only.
You must not connect any other
equipment, such as a VCR, to this input.
POWER INPUT
15 volt power
supply unit
To ensure correct
operation, use this
set-top box only with the
Pace-approved power
supply unit provided. If
you use an unapproved
alternative, you will
invalidate the warranty.