AeGIS8000P
Page 13
Chapter 3
PROGRAMMMING
I.
Two ways to Log-on to programming mode:
First using system’s keypad
1.
Press 0 and # simultaneously then release
, see below
Press 0# simultaneously, LCD screen will stop scrolling
if the LCD is still scrolling repeat the process
then 4-digit Master Code (0000 is default master code)
2. The screen will show as below, if the master code is valid
Long beep, if the master code is invalid
, need key to unlock the system then use the second method
to log-on to programming.
3. Select the programming function code.
Second using the Master Code retrieval button on page 11
1. Press and release black button (see figure 2.1, step 10), then the display will show:
2. Select the programming function code.
Select Func: _ _
Select Func: _ _
Summary of Contents for AeGIS 8000 PLUS
Page 1: ...INSTALLATION AND PROGRAMMING MANUAL Rev 02 2011...
Page 29: ...AeGIS8000P Page 29...
Page 30: ...AeGIS8000P Page 30...
