Pacific energy MIRAGE 30 SERIES A, Installation And Operating Instructions Manual

17

180516-36

5055.MR30-A

Remote Transmitter Description 

The Proflame 2 Remote Control consists of two elements:

1. 

Proflame 2 Remote Control Transmitter.

2. 

Proflame Integrated Fireplace Control (IFC Module) board and a wiring harness to connect the IFC to the gas   

valve and stepper motor (Figure 11). 

Transmitter (Remote Control with LCD Display)

The Proflame2 Transmitter uses a streamline design with a simple key layout and an informative LCD display (Figure 15). 
The remote control transmitter is powered by 3 AAA batteries. A mode key is provided to index between the features and 
a thermostat key is used to turn on/off or index through thermostat functions

 (Figure 14).

IFC Module

The Proflame 2 Integrated Fireplace Control (IFC) module is a device that allows automatic ignition and pilot flame super-
vision and commands the functions of the fireplace. It’s configured to control the ON/OFF main burner operation, giving 
the choice of both IPI (intermittent pilot ignition), and CPI (continuous pilot ignition) modes. The Proflame 2 IFC module 
controls and connects directly to the pilot assembly and the automatic valve using low electric power.

The IFC module can be powered by both an AC power supply, and battery pack for back up. The Proflame 2 offers the 
added ability to control the comfort fan speed from OFF through six (6) speeds. The external batteries can provide DC 
power to the IFC allowing the batteries to be used only when line power is interrupted or lost.

Operating Procedure

Initializing the Fireplace for the first time

1.  With the gas stove power plug unplugged and the main switch - located in the rear of the stove, turned to 

the OFF position, remove the switches’ face plate and install 4 AA batteries into the battery holder (Figure 
10). Once the batteries are installed and the switches’ face plate reattached, turn the selection switch to    
“Remote” setting. 

2.  Install 3 AAA batteries into the Proflame2 Remote Control Transmitter (Figure 16). 

3.  Plug the power plug in and turn on the gas supply. 

4.  Insert a straightened paper clip into the opening marked “PRG” of the  switches’ face plate (Figure 10) 

and press the program key once (alternately, if the face plate is already off, simply press the “PRG” button 
on the battery holder). The IFC module, also located on the inside of the gas stove enclosure, will beep 3 
times indicating that it is ready to synchronize with a remote control transmitter. 

5.  On the remote control transmitter, push the power on key once. The remote control transmitter will beep 

4 times to indicate that the remote control transmitter and the IFC module are now synchronized. The 
remote control transmitter is now ready to use.