22
5055.MR30-A
180516-36
Propane Conversion
Before starting the conversion make sure to shut off the gas supply
to the unit and allow stove to cool to room temperature.
To convert the gas stove from natural gas to propane, the
(GASC.LP18KIT) kit is required. This kit comes with new pilot and burner
orifi ces as well as a new pressure modulator for the valve.
To switch the pressure modulator, follow the instructions that are provided
with the conversion kit.
To change the orifi ces you are required to remove the door, and side
cladding on your right. Please refer to the appropriate sections of
this manual and follow instructions on how to correctly remove the
components.
After removing the side cladding you will have access to the burner
orifi ce’s mounting plate on right side of unit. To access the orifi ce remove
the two nuts securing the mounting plate and pull from side of unit
(Figure 30) . The orifi ce can be removed using a ½” socket. Before
installing the new orifi ce, Loctite 567 Thread Sealant needs to be applied
to the threads of the new orifi ce to ensure a proper seal when installed.
To replace the pilot orifi ce or to clean the pilot itself, you will need to
remove the pilot hood which is held in place by a spring. First remove
the spring, (Figure 29) and then remove the hood by pulling it up from
the pilot bracket. To remove the existing orifi ce insert a 5/32” or 4mm
Allen wrench into the hexagonal key-way of the orifi ce and rotate counter-
clockwise until free. Insert the new orifi ce using the same Allen wrench
and tighten it until a torque of 9 lbf in (1 Nm) is achieved. Replace the
pilot hood by aligning the tab on the base of the hood with the slot in the
side of the pilot journal, and push the hood down onto the pilot bracket.
Replace the spring by pushing it onto its seat.
Before reinstalling the cladding, the venturi shutter will have to be
adjusted to the correct opening - See (“Air Adjustment” on page 29) for
correct adjustment of venturi.
Pilot
Nuts
Orifi ce
Figure 28: Mirage 30 Pilot.
Figure 29: Pilot hood.
Figure 30: Orifi ce extraction.
Summary of Contents for MIRAGE 30 SERIES A
Page 33: ...33 180516 36 5055 MR30 A ...
Page 34: ...34 5055 MR30 A 180516 36 ...
Page 35: ...35 180516 36 5055 MR30 A ...
