Pacific energy MIRAGE 30 SERIES A, Installation And Operating Instructions Manual

8

5055.MR30-A

180516-36

1.  Measure chimney height, cut fl ex liner (min.10’ 

to termination) as  required. Mark one pipe at 
both ends to identify  combustion air intake 
pipe from fl ue outlet pipe.

2.  Attach marked fl ex liner pipe to the intake side 

of  vent terminal. Seal and secure with sealant 
and  screws provided. Attach the other pipe 
to the outlet  side of vent terminal. Seal and 
secure with sealant  and screws provided. 

3.  Insert both fl ex liners from top of the chimney, 

down  through the damper opening. 

4.  Before attaching vent terminal to top of chim-

ney,  apply a bead of caulking to top of clay 
liner. Slip  vent terminal over liner and secure in 
place with  lateral retaining bolts.

5.  For larger chimneys, fl ashing will need to be 

constructed according to local building codes.

Intake 

Air

Exhaust 

Air

 Co-Linear Venting 

Figure 5:   Mirage co-linear venting.

NOTE:

If venting the Mirage 30 through an existing 
fi replace opening using a co-axial to co-lin-
ear adapter, the customer will have a couple 
of aesthetic options which include:

1.  sealing up the existing fi replace opening 

with a cover or other material, leaving 

room in the cover or other material to 
accomodate the adapter so that it is 
positioned fl ush (Figure 5) with the cover 
or other material.

2.  Position the Mirage 30 so that it and the 

adapter are located outside of the exist-
ing fi replace opening. 

Co-Axial to 
Co-Linear 
adapter

Co-Linear Venting 
Notes: 

• 

Mirage 30 requires a 3 
inch diameter exhaust 
vent and a 3 inch 
intake vent. 

• 

Max. Vent Height 50’ 

(15.25M) to termination

• 

Min. Vent Height 10’ (3m) 
to termination.

High wind cap

Prairie cap

Simpson Duravent High-Wind (cap style) Co-Linear 
Kit w/Flex (46DVA-CL34) or Simpson Duravent Prairie 
(cap style) Co-Linear Kit w/Flex (46DVA-CL34P) are 
recommended for use with this appliance. 
Visit http://www.duravent.com for kit details.  

^  a vent shall not terminate directly above a side-walk or paved driveway which is located between two single family dwellings and serves both dwellings*

**  only permitted if veranda, porch, deck, or balcony is fully open on a minimum of 2 sides beneath the fl oor*

*   as specifi ed in CGA B149 Installation Codes, Note: local Codes or Regulation may require different clearances

*   for U.S.A. Installations follow the current National Fuel Gas Code, ANSI Z223.1