background image

2                                                                                                                                                                       

SINC  250314-24

Contents

Safety ............................................................................................ 3

Clearances ................................................................................... 3

Masonry or Factory Built Fireplace ........................................................ 3

Maintenance Checks ................................................................... 4

Dimensions .................................................................................. 6

Mantel Clearances ................................................................................. 6

Installation .................................................................................... 7

Fireplace Specifi cations ......................................................................... 7
Into a Masonry Fireplace ....................................................................... 7
Full Flue Liner  - (Required in Canada) .................................................. 8
Direct Flue Connection (USA only) ........................................................ 8
Into a Factory Built Fireplace ................................................................. 9
Combustion Air ...................................................................................... 9
Surround Assembly and Installation .....................................................10
Fan Speed Controller Relocation .......................................................... 11

Operation .................................................................................... 13

Wood Selection.....................................................................................13
How to Test Your Wood .........................................................................13
Lighting the Fire ....................................................................................13
Normal Operation .................................................................................13
Restarting After Extended or Overnight Burns ......................................13
Over Firing ............................................................................................14
More Wood, More Heat .........................................................................14
Proper Draft ..........................................................................................14
Ash Removal ........................................................................................14
Disposal of Ashes .................................................................................14

Blower ......................................................................................... 14

Blower Operation ..................................................................................14
Electrical Supply ...................................................................................14

Creosote ..................................................................................... 15

Formation and Need for Removal .........................................................15
Chimney Fires .......................................................................................15
In Case of a Chimney Fire ....................................................................15
Avoiding a Chimney Fire .......................................................................15

Maintenance ............................................................................... 16

Baffle Removal ......................................................................................16

Appendix A ................................................................................. 17

Understanding & Operating Your Pacifi c Energy Stove .........................17
Troubleshooting ....................................................................................18

Firebrick Installation .................................................................. 19

Replacement Parts .................................................................... 20

Label .................................................................................................... 23

NOTE: 
WE STRONGLY 
R E C O M M E N D   T H AT 
SMOKE DETECTORS BE 
INSTALLED.

If smoke detectors have been previ-
ously installed, you may notice that 
they are operating more frequently. 
This may be due to curing of stove 
paint or fumes caused by accidentally 
leaving the fi re door open. Do not 
disconnect the detectors. If neces-
sary, relocate them to reduce their 
sensitivity.

SAFETY NOTICE:

If this stove is not 
properly installed, a 
house fi re may result. 
For your safety, fol-
low the installation 
instructions.  Contact 
local building or fi re 
officials about restric-
tions and installation 
inspection require-
ments in your area.

Please read this entire manual before 
you install and use your new room 
heater. Failure to follow instructions 
may result in property damage, bodily 
injury, or even death.

Summary of Contents for SUMMIT INSERT

























Reviews: