- 17 -
SQUEEGEE SYSTEM
Squeegee Blades and system should be inspected and maintained regularly to achieve peak machine performance.
REMOVAL & INSTALLATION
Install: Align the slots in the squeegee assembly with the easy-grip knobs, attach the vacuum hose, and tighten the knobs.
Remove: Loosen the easy-grip knobs, remove the vacuum hose, and remove the assembly.
SQUEEGEE USE
Operating the machine in either VACUUM ONLY or SCRUB mode will cause the Squeegee Actuator to lower the
assembly and the vacuum motor to turn on. Deselecting VACUUM ONLY or SCRUB mode will cause the squeegee
assembly to lift and the vacuum motor to shut off after a 60 second delay. This delay ensures all of the recovered water is pulled into
the recovery tank.
SQUEEGEE ADJUSTMENT
Improper adjustment of the squeegee blades will reduce the systems ability to properly pick up water. The leading edge of the rear
squeegee blade should contact the floor at a 45° angle (similar to the image shown below). The height of the squeegee system is
adjusted using the two cap head screws located next to the easy-grip knobs. Raise (by turning the screws clockwise) or lower (by
turning the screws counter-clockwise) until the proper blade deflection is achieved. When the system is adjusted properly, the small
gray wheels on the squeegee system should be approximately 1/32” off of the floor.
Summary of Contents for RS28
