- 15 -
DISK SCRUB HEAD
STANDARD OPERATION
NOTE
: Do not operate the Disk Scrub Head without a pad installed on the pad driver. Operating the head without a pad will damage
the floor.
1. With power off and the Scrub Head raised, lift the Side Squeegees to the raised position.
2. Align the pad driver assemblies with the bayonet drivers on the machine.
3. Lower the scrub head onto the pad driver assemblies (by turning power onto the machine and selecting SCRUB ONLY or
SCRUB mode).
4. Ensure the bayonet drivers are properly engaged with the pad driver assemblies.
5. Lower the Side Squeegees.
6. Drive the machine forward and listen for the bayonet drivers to lock onto the pad driver assemblies.
7. The machine is ready for operation.
1. With power off and the Scrub Head raised, lift the Side Squeegees to the raised position.
2. Grab the pad driver assemblies and rotate by hand to disengage from the bayonet drivers.
3. Lower the Side Squeegees.
DISK REMOVAL
Summary of Contents for RS28
