- 2 -
CAUTION
: Keep hands away from spinning brushes.
CAUTION
: Do not modify the machine from its original design.
CAUTION
: Wear non-slip shoes when operating machine.
CAUTION
: Reduce speed when turning or operating on inclines and slippery surfaces.
CAUTION
: Use Bromine only in your tank treatment system! Do not use chlorine. Chlorine can interact with ammonia-based
detergents and cause harmful fumes.
CAUTION
: Follow mixing and handling instructions on chemical containers.
CAUTION
: Remove the batteries, use a jack, and get assistance before lifting the machine.
CAUTION
: Park and service the machine on a level surface and remove the key.
CAUTION
: Always wear protective clothing, gloves and goggles when handling and charging batteries.
CAUTION
: Avoid moving parts and do not wear loose jackets, shirts or sleeves when servicing.
NOTE
:
Do not hose down or use a power-spray on the machine. Electrical malfunction may occur.
NOTE
:
All repairs must be performed by a qualified service technician using approved replacement parts.
NOTE
:
To avoid damaging the floor, do not allow the brush/pad to operate while the machine is stationary.
NOTE
:
Use a ramp with no more than a 12% incline when loading or unloading the machine.
NOTE
:
Use tie down straps to secure the machine to the truck or trailer during transport.
NOTE
:
Discontinue use and report machine damage or faulty operation immediately.
NOTE
:
Store the machine indoors where the temperature is between 32º and 104ºF (0º and 40ºC).
NOTE
:
Do not lower the orbital head without a pad. Doing so damages the Mighty-Lok
®
face.
NOTE
:
Failure to clean the BatteryShield
®
light pipe will limit the system’s ability to read the water level and will reduce
battery life.
NOTE
:
Do not use an extension cord. This will void the warranty on the charger.
NOTE
:
Batteries designed for automotive or marine and RV use are not suited for use in floor scrubbers.
NOTE
:
Use of an unapproved water supply or modification of an approved water supply can lead to battery system failure.
NOTE
:
Ensure battery charging and storage locations comply with OSHA and any governing agencies’ standards based on
your particular location and application.
NOTE
:
When loading/unloading machine for transport:
•
Fully drain the Solution and Recovery tanks before loading.
•
Transport the machine with the scrub head in the lowered.
•
Ensure the ramp and truck/trailer are properly rated for the weight of the machine.
•
Do not lower the Orbital Scrub Head without a pad installed.
•
Chock the wheels and tie down the machine.
CONTINUED
SAFETY INFORMATION
Summary of Contents for S-20
