- 15 -
DISK SCRUB HEAD
DISK INSTALLATION
NOTE
: Do not operate the Disk Scrub Head without a pad installed on the pad driver. Operating the head without a pad will damage
the floor.
DISK REMOVAL
1. Toggle the “Brush On/Off” switch to position “A” for 1 second and then immediately to position “B”. The brush will spin in posi
-
tion “A” and abruptly stop in position “B”, releasing the pad drivers.
2. Remove the center lock fitting by squeezing the wires inward and pulling the center lock away.
3. To connect the cleaning pad to the drivers, center the pad on the driver, squeeze the center lock wires inward, and press down (tab
side first). Press the pad and release the wires so that they lock in place.
1. Turn the key switch on and rotate the speed control knob to the full slow position.
2. Place the pad drivers or brushes on the floor in front of the scrub head.
3. Push or drive the machine into position centering the scrub head over the pad drivers or brushes.
4. Lower the scrub deck onto the pad drivers or brushes.
NOTE
: When properly aligned, the scrub deck shroud bristle skirt should almost be touching the floor.
5. Quickly squeeze and release the Bail to engage the pad driver or brushes.
NOTE
: If the pad drivers or brushes do not quickly engage, return to step two and try again.
Summary of Contents for S-20
