- 16 -
RECOVERY SYSTEM
RECOVERY TANK
To drain and rinse the recovery tank:
1. Remove the Recovery Drain Hose from the holder and lower the end into the drain location.
2. Remove the press-fit cap from the Recovery Drain Hose, squeezing the restriction collar to control the flow.
3. As the tank drains, lift the Recovery Tank to the open position.
4. Using clean water, thoroughly clean and rinse out any sediment in the Recovery Tank.
NOTE:
Periodically use cleaner and sanitizer with a cloth or sponge to prevent mold and mildew.
5. Inspect and vacuum the mesh filter screen around the ball float system.
6. Leave the lid open to dry.
Summary of Contents for S-20
