SKU 65322 or 65323
For technical questions, please call 1-800-444-3353.
Page 7
Set uP inStructionS
read the entire imPortant
SaFety inFormation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
to Prevent
SeriouS injury
From acciDentaL
Starting:
turn the Power Switch of the
equipment to its “oFF”
position, wait for the engine to
cool, and disconnect the
spark plug wire(s) before
assembling or making any
adjustments to the equipment.
to Prevent
SeriouS injury:
operate only with proper
spark arrestor installed.
operation of this equipment
may create sparks that
can start fires around dry
vegetation.
a spark arrestor may be
required.
the operator should contact
local fire agencies for laws
or regulations relating to fire
prevention requirements.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
Inlet and Outlet Pipes (12) must be
1.
attached prior to use. Additional inlet
and outlet hoses and clamps (not
included) will be needed depending
on the specifics of use.
Remove the Pipe Clamps (13) from
2.
both Inlet and Outlet Ports of the
Pump Housing (10) by turning coun-
terclockwise.
Place Pipe Clamp (13) over Inlet
3.
or Outlet Pipe (12). Position Inlet /
Outlet Gasket (11) at Inlet or Outlet
Port of the Pump Housing (10). Posi-
tion Inlet or Outlet Pipe (12) at Inlet
or Outlet Port, and secure in place by
turning Pipe Clamp (13) clockwise.
Hand tighten firmly. See
Pump as-
sembly Diagram
on page 20.
oPerating inStructionS
read the entire imPortant
SaFety inFormation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Starting the engine
inspect engine and equipment
looking for damaged, loose,
and missing parts before
set up and starting. if any
problems are found, do not use
equipment until fixed properly.
checking and Filling engine oil
caution!
Your Warranty is VOID if the
engine’s crankcase is not properly
filled with oil before each use. Before
each use, check the oil level. Do not
run the engine with low or no engine
oil. Running the engine with no or
low engine oil WILL permanently
damage the engine.
