11
Electrician Installation Manual
EM-E Ceiling Fan
1.
Do not
attempt to operate the fan (or optional light kit) with any wall control that is not
approved by Pacific International Fans for use with its fans. DO NOT use solid state
controllers. The use of unapproved controllers will void your warranty.
2.
Do not
mix blade sets from one fan to another as this may upset the balance of the fan. If
only one blade is damaged you are still required to replace with a new set.
Attaching an extension rod - genuine rods to be used ONLY
Step 1 (Fig. 24)
Loosen and remove the down rod screws and
the down rod pin screw to remove the
standard down rod from the motor housing.
Step 2 (Fig. 25)
Loosen the ball joint screw, take out the ball joint
pin and remove the ball joint. Then slide off the
canopy cover.
Fig. 17
Down Rod
Tighten Ball
Joint Screw
Ball Joint
Ball Joint Pin
Fig. 27
Step 3 (Fig. 26 & 27)
Now install the extension rod and
reverse step 1 & 2 to secure the rod to
the fan and the ball joint.
NOTE:
If the extension rod needs to be shortened, cut the rod to the required length and drill
the appropriate hole size to fit the ball joint pin. The cut end of the rod should be used on the
ball joint end only. When installing a 1.8m extension rod the wiring will need to be extended and
joined. This should be done using crimp style connectors.
Ball Joint Pin
Ball Joint
Loosen
Ball Joint
Screw
Down Rod
Down Rod
Ball Joint
Fig. 25
Ball Joint
Canopy Cover
Washer
Cotter Key
Down Rod
Screw
Connection Collar
Cotter Pin
Fig. 24
Reverse
Switch
Cover
Ball Joint
Canopy Cover
Washer
Cotter Key
Down Rod
Screw
Connection Collar
Cotter Pin
Fig. 26
Reverse
Switch
Cover
