81
SECTION 4
OPERATION
4.0 OPERATION
This section describes the operation of an AMX-Series AC Power Source. The procedure
described in the following paragraphs is a general procedure common to all systems (except
as noted). This procedure does not detail operation of a specific controller. Refer to the
appropriate controller manual for detailed information regarding the installed controller.
4.1
FRONT PANEL CONTROLS
Figure 4.1 is a front view of the Model 320-AMX with a UPC-32 controller installed, showing
the location of the front panel controls and indicators of the 320-AMX-Series Power Source.
The front panel control layout is similar in all AMX-Series models. Refer to the
UPC-Series
OPERATION MANUAL
for information about the installed controller.
1.
INPUT POWER SWITCH
(Circuit Breaker)
The circuit Breaker is used as the main input ON/OFF control and protects the power
source from drawing excessive input current from the input AC line.
2.
OUTPUT POWER SWITCH and INDICATORS
This Switch is used to control the output contactor of the AMX-Series Power Source.
Indicators show the state of the output contactor. If the power source shuts down for
the case of over-temperature or other internal fault, shutdown is reset when the
Output Power Switch is set to OFF and the fault has cleared. Refer to Paragraph 4.5
for details.
3.
OUTPUT COUPLING INDICATORS
LED's which show the Output Coupling of the power source.
4.
OUTPUT FORM INDICATORS
LEDs show the Output Form that is active. (The 3 Phase indicator is not present on
the Models 105, 108, 112, 125, 140, 160-AMX.)
Summary of Contents for 105-AMX
Page 1: ...AMX SERIES AC POWER SOURCE OPERATION MANUAL PACIFIC POWER SOURCE ...
Page 2: ......
Page 8: ......
Page 114: ......
