LMX SERIES™ OPERATION MANUAL
SECTION 8:
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Page 262 of 463
Commands
Command Syntax
[SOURce:]WAVEFORM:AUTORMS <BOOLEAN>
Description
If enabled, the value of the waveform is normalized in order to match
the RMS set point.
If disabled, the waveform is reproduced without any normalization.
This function is useful for waveform substitution at the steady state
level.
Note:
This function is related to the AUTORMS function in the
transient segment but it is
not
the same.
Note:
UPC has AUTORMS always enabled for steady state. It is not an
option in UPC Mode.
Parameters
0 | 1 | ON | OFF
Parameter Format
<b>
Example
WAVEFORM:AUTORMS OFF
Query Format
[SOURce:]WAVEFORM:AUTORMS?
Returned Data Format
<b>
Query Example
SOURce:WAVEFORM:AUTORMS?
0
Query Format
[SOURce:]WAVEFORM:CATalog?
Description
This command returns the list of available waveforms by name.
Names can only be numbers. For more descriptive names, see the
.”
[SOURce:]WAVEFORM:CATalog:ALIAS?”
command instead.
Returned Data Format
<cr>
Query Example
WAVEFORM:CAT?
1,2,3,4,5,6,7,8,9,10,11,12,13,14,15,16
Query Format
[SOURce:]WAVEFORM:CATalog:ALIAS?
Description
This command returns the list of available waveforms by description.
For each waveform, both the name (number) and description are
returned in a comma separated list.
Returned Data Format
<cr>
Query Example
WAVEFORM:CAT:ALIAS?
Sine,Clipped THD 1%,Clipped THD 2%,Clipped THD 5%,Clipped THD
10%,Square Fast,Square Slow,Sawtooth Fast,Sawtooth
Slow,Triangle,Clip 5% THD,Clip 6% THD,Clip 7% THD,Clip 8% THD,Clip
9% THD,Clip 10% THD
Command Syntax
[SOURce:]WAVEFORM:COPY
Description
This command copies the waveform file specified as a PATH
parameter to the waveform number specified. The path name is a
delimited string.
Parameters
<PATH>,<NUMBER>
Parameter Format
<cr>,<nr1>
Example
WAVEFORM:COPY “internal/waveforms/1.csv”,25
