LMX SERIES™ OPERATION MANUAL
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Page 375 of 463
10.3.1
Browser Access Control
When connecting to the power source via a browser on which access has been restricted, the
following message will appear:
The browser Access dialog is shown below.
Figure 10-2: ACCESS CONTROL Dialog Screen
If the operator knows the four-digit access password that was set on the actual unit, he can
enter the password code and gain full control of the source.
If the operator does not know the password, he can request access. Such a request can only be
granted by a person who is in front of the actual unit however. This prevents unauthorized
access from a remote location and protects the local user from possible harm. An Access
Request will result in a Pop-Up message on the power source LCD screen.
The access control password can be set/changed only by the person(s) present at the physical
location of the unit. Factory default password is “1234” but it is strongly
advised
the end user
changes this to his own code after receipt of the unit.
If access is denied, the browser interface will enter MONITOR only mode in which
measurements and settings can be viewed remotely but control is possible. When in this mode,
a user with knowledge of the access password can enter FULL CONTROL mode by supplying the
correct password or request full access from a local operator that is present at the unit’s
location.
