ADF SERIES® OPERATION MANUAL
SECTION 4: TECHNICAL SPECIFICATIONS
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
Page 25 of 349
4.3
AC Output Mode
AC OUTPUT
Voltage
AC Range
0 - 300 V L-N rms / 0 - 520V L-L rms
Extended Voltage Range
1
(Option V)
0 - 333 V L-N rms / 0 – 576 V L-L rms, see Note 1
Programming Resolution
0.01 V
Accuracy
± 0.25% F.S.
Waveform
Sine wave
DC Offset
< 20 mV
Harmonic Distortion
2
(Vthd)
(Full, Resistive Load)
< 0.5% 15Hz – 400Hz, < 1.0% 400Hz-1000Hz, < 1.5% > 1000Hz
See V THD Chart at bottom of page
Output Noise (DC – 300 kHz)
< 150 mV rms
Load Regulation
± 0.02% (CSC Mode on)
Line Regulation
± 0.1% for 10% Line Change
External Voltage Sense
External Sense, max. voltage drop 5% FS.
Voltage Slew Rate
At least 1.0 V/us
Isolation
550 Vac
Frequency
Range
45.00 – 500.0 Hz
Extended Frequency Range
(Option F)
15.00 – 1200.0 Hz
Programming Resolution
3
0.01 Hz
Accuracy
± 0.01%
Current Limit
Range
4
See model tables, Figure 4-3 and Figure 4-4. Values shown are supported for
any period of time.
Current Overload
Available 30% Current overload for up to 2.0 seconds when enabled. See
Crest Factor
2.5:1 @ 41.67 to 6.3:1 @ 16.67
(104Apk / phase for 3150ADF, 312Apk for 1150ADF)
Programming Resolution
0.01 A rms
Accuracy
± 0.5% F.S.
Modes
Constant Current Mode or Output Trip
Phase Angles (3 Phase Models)
Phase Offsets
5
A = 0°, B = 240°, C = 120
Accuracy
± 0.35°
Note 1:
Extended operation to 333V L-N / 576V L-L supported in Three and Split Phase mode up to 3.3kVA per phase
for frequency range 45Hz ~ 800Hz with Option F. Some specifications exceptions apply. Requires Option V.
Note 2:
Refer to Figure 4-1, “Output Voltage distortion into full R Load as
” on next page.
Summary of Contents for 1150ADF
Page 348: ......
