1
+
1
+
17
16
4
4
wifi
(This function is available only if an in.touch module is connected to your system.)
WiFi Settings
To modify WiFi network settings, slide the right
wheel until the WiFi icon is highlighted in the
middle.
in.touch Module Not Connected
If the in.touch module of your spa system is not
connected, this message will be displayed.
WiFi Networks
After a few seconds the available networks will
appear on-screen, as well as their signal strength.
The selected network will be identified by a green
check mark.
Swipe up or down the list to select your network.
WiFi Network Password
If the WiFi network is password protected, enter
it at the keyboard prompts. Use Enter key to
validate the password.
If no password is required, the in.touch will
connect automatically.
About
To get information about your spa system, slide
the right wheel until the About icon is highlighted
in the middle.
Information about the in.k1000+ software
number and the revision numbers of the various
components of your system will be displayed.
about your spa system
WiFi (in.touch 2)
When in.touch 2 is detected, this network
will appear (in.k1000+ version 12 and older).
electrical configuration
Please do not make changes in this section
unless you are a qualified electrician.
direct to
function
selection
wheel:
training drills -
selection -
swim settings -
mode
selection
wheel:
swim mode
swim mode
(only available if the swim option is activated in the spa configuration)
The duration of all training drills and the Intensity
of all pre-set training drills are set on this page.
The number of available intensities depends on
the swim spa configuration and on the selected
training drill, with the name displayed at the top
of the screen. The intensity of personalized drills
is set during the Drill Creation and can be edited
from the Training Drills selection page.
From this page, you can also access the following:
∙ Training drills selection
∙ Swim settings
To select an item, slide the right wheel until the
desired icon is highlighted in the middle.
When ready, press Start to begin the workout
session. Resume and Stop buttons are also
available when a swim session was previously
paused.
swim settings
In the Swim Settings page, you can access the
following parameters:
∙ Warm up
∙ Cooldown
∙ Step Time
∙ Preparation Time
∙ Light (requires in.mix installed)
Preparation Time
This page allows you to adjust the Preparation
Time. The preparation allows the swimmer to take
place between the time when s/he presses the
Start button of the Swim page and the time when
the swimming workout starts. If no Preparation
Time is desired, set Duration to 0 seconds.
Warm Up & Cooldown
These pages allow you to adjust the duration and
intensity of the Warm up and Cooldown portion
of your training drill. If no Warm up or Cooldown
sessions are desired, set their respective duration
to 0 minutes.
Note that Warm up and Cooldown settings apply
to all training drills.
Light (requires an in.mix installed)
This page allows you to select which in.mix zone
to use for swim feedback. If at least one zone is
selected for feedback, it will blink and change
colour depending on the progression during the
swim workout:
1.
Blinks in blue during the preparation
countdown
2.
Changes to yellow during the warm up
session
3.
After the warm up, colour tones range from
light blue to bright red depending on swim
intensity
4.
Blinks twice when the intensity changes
during the workout
5.
Changes to a light blue colour during the
Cooldown session
Step Time
This page allows you to adjust the workout session
Step Time. Step Time applies to all training drills
except Endurance, Power and Personalized.
