IMPORTANT SAFETY INSTRUCTIONS
To ensure the safe operation of this machine, you must read and understand all warnings and instructions in this book. If you
do not understand, ask your supervisor.
READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE
WARNING
: To reduce the risk of fire, electric shock, or injury:
1. You must be trained to operate this machine. This machine is to be operated for its intended use only.
2. Do not operate this machine unless it is completely assembled.
3. Always use a three-wire electrical system connected to the electrical ground. For maximum protection against electrical
shock, use a circuit that is protected by a ground fault circuit interrupter. Consult your electrical contractor.
4. To prevent electric shock, always remove the electrical plug from the electrical outlet before doing any repairs or mainte-
nance and when leaving the machine unattended.
5. To prevent electric shock, keep the machine surface dry. Do not subject to rain. Store the machine in a dry building area.
Clean the machine with a dry cloth only.
6. Machines can cause an explosion when near flammable materials and vapors. Do not use this machine with or near fuels,
grain dust, solvents, thinners, or other flammable materials. Do not use flammables to clean this machine.
7. A qualified or authorized person must do maintenance and repairs.
8. To prevent damage to the power cord, do not move this machine over the power cord. Always lift the power cord over
the machine. Do not pull or carry cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or
corners. Keep cord away from heated surfaces.
9. Do not use with damaged cord or plug. If the machine is not working as it should, has been dropped, damaged, left out-
doors, or dropped into water, return it to a service center.
This machine must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for electric current to
reduce the risk of electric shock. This machine is equipped with a cord having an equipment-grounding conductor and grounding plug. The
plug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
WARNING
- Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. Check with a quali-
fied electrician or service person if you are in doubt as to whether
the outlet is properly grounded. Do not modify the plug provided
with the machine. If it will not fit the outlet, have a proper outlet
installed by a qualified electrician.
This machine is for use on a nominal 120-volt circuit, and has a
grounded plug that looks like the plug illustrated in figure A. A
temporary adapter that looks like the adapter illustrated in figures
B and C may be used to connect this plug to a 2-pole receptacle
as shown in figure B if a properly grounded outlet is not avail-
able. The temporary adapter should be used only until a properly
grounded outlet (figure A) can be installed by a qualified electri-
cian. The green colored rigid ear, lug, or the like extending from
the adapter must be connected to a permanent ground such as
a properly grounded outlet box cover. Whenever the adapter is
used, it must be held in place by a metal screw.
NOTE: In Canada, the use of a temporary adapter is not permitted
by the Canadian Electrical Code
EXTENSION CORDS
Use only three-wire 12/3 or larger gauge approved extension
cords that have three-prong grounding type plugs and three-pole
receptacles that accept the appliance’s plug. Replace or repair any
damaged cords or plugs.
When servicing, refer to authorized person only. Use only identi-
cal replacement parts.
Grounding Instructions
NOTE:
Do not use adapters shown in figures B & C in Cana
da
2
