OPERATING PROCEDURES
WARNING! For the safe operation of this machine
follow the instructions given in this booklet and
the training given by your supervisor. Failure to
do so can result in personal injury and/or damage
to machine and property!
DO NOT OPERATE MACHINE IN AN EXPLOSIVE EN-
VIRONMENT!
The model shown in this manual is intended for com-
mercial use.
PREPARATION
To prepare the machine for operation, make sure it is of
correct voltage and properly assembled.
Your new floor machine operates in the normal side to
side motion of a conventional single disc machine. Be
prepared before starting by removing all obstructions or
other obstacles in the area to be cleaned. Check the
proper application recommendations and procedures
found on the label of your cleaning or finish container.
IF IN DOUBT, CALL
YOUR SUPERVISOR .
WARNING! NEVER USE THIS MACHINE WITH FLAM-
MABLE OR EXPLOSIVE MATERIAL!
For Scrubbing or Polishing:
Select the correct
floor pad or brush (your supplier can help you). If in
doubt, ask your supervisor. DO NOT USE BLACK PADS
with this unit due to possible motor overloading.
NEVER OPERATE THE MACHINE WITHOUT THE
FLOOR PAD OR BRUSH INSTALLED!
To properly attach the brush, UNPLUG THE FLOOR
MACHINE, lay the machine on its side and remove the
screw in the bottom of the drive adaptor. Position the
brush or pad on the drive adaptor. Assemble the at-
tachment screw and tighten.
Plug the machine’s power cable into a properly grounded
outlet (see Safety Instructions). Next, adjust the handle
height to a comfortable position.
Start the machine by depressing the trigger switch in
the handle.
The machine will glide sideways over the floor by a slight
raising and lowering of the handle. Raise the handle
slightly to go left, or lower the handle slightly to go right.
Releasing the switch lever stops the machine.
MAINTENANCE
AFTER EACH USE:
Store the machine in a clean dry
area. Wipe the entire machine and cord down with a
clean cloth. CHECK the cord and plug for nicks, cuts or
damage. Report these to your supervisor for correc-
tion. Remove the pad or brush and clean thoroughly.
NOTE: To prevent brush damage and reduce wobble
problems, do not store the unit with the machine weight
on the brush. Either remove the brush or support the
unit on a hook while in the storage position.
WARNING! Always disconnect the machine’s elec-
trical plug from the electrical outlet before per-
forming any service, maintenance, pad changing
or inspection of the machine.
MOTOR:
The motor is lubricated for life under normal
use. No oiling or greasing is necessary.
If you have any questions regarding the maintenance of
your floor machine, ASK YOUR SUPERVISOR.
OPERATION
3
