9.
OVER FILL PROTECTION
The machine is equipped with a float that stops the vacuum exhaust air flow when the
recovery tank is full. Vacuum motor does not stop operating but the vacuum exhaust air flow
rate is greatly reduced. When this occurs, empty the recovery tank by removing the drain
plug on the drain hose and then empty the recovery tank
WARNING!
Use gloves for protection from contact with dangerous solutions
After finishing your work and before any type of maintenance is done, it is necessary to do the
following
:
1. Close the water valve by raising the solution flow control lever
2.
Raise the brush base by stepping down locking the brush base lift lever. To lock the lever
move your foot to the right while the lever is pressed down
3. Lift the squeegee by raising the squeegee lift lever and locking it by moving the lever to the left
WARNING! The squeegee blades can be damaged if the squeegee is not raised
during storage or transport
MACHINE OPERATION
UPON COMPLETION OF MACHINE USE
9
Summary of Contents for Z210
Page 34: ...34 WIRING DIAGRAM DRAWING 10...
