10. SPLASH GUARD INSTALLATION
a. Wrap splash guard around the brush deck base
b. Place band clamp over the front band clamp stud
c. Pull band clamp around brush deck base and place and clamp spring over rear band clamp stud
d. Repeat process on opposite side of brush deck base
MACHINE OPERATION
1. Connect machine connector to the battery connector
2. Turn on the main power key switch. Battery charge indicator will illuminate indicating the charge level of
the batteries. If the indicator is flashing then the batteries need to be charged or a fault has occurred.
Call technical service if problem persists after charging
3. Turn on the brush motor switch. Please note that the scrubbing brushes will not rotate until the hand
switch lever is engaged
4. Turn on the water solenoid valve switch
5. Turn on the vacuum motor switch
7
MACHINE PREPARATION
