Page 11 of 38
UPON COMPLETION OF MACHINE USE
After finishing your work and before any type of
maintenance is done, it is necessary to do the
following
:
1) Close the water valve by raising the solution
flow control lever.
2) Raise the brush base by stepping down
locking the brush base lift lever. To lock the
lever move your foot to the right while the
lever is pressed down.
3) Lift the squeegee by raising the squeegee lift
lever and locking it by moving the lever to the
left.
WARNING! The squeegee blades can
be damaged if the squeegee is not raised
during storage or transport.
4) Switch off the water solenoid valve switch.
5) Switch off the brush motor switch.
6) Switch off the vacuum motor switch.
7) Transport the machine to the location where
the recovery tank should be emptied.
8) Remove the drain hose at the front of the
recovery tank.
9) Remove the drain plug and empty the
recovery tank.
WARNING!
Use gloves for protection
from contact with dangerous solutions.
10) Remove the brushes or pad drivers and clean
them with clear water.
Squeegee
Lift Lever
Brush Base
Lift Lever
Solution
Flow
Control
Lever
Vacuum
Motor
Switch
Water
Solenoid
Switch
Battery Charge
Indicator
Brush Motor
Switch
Drain Plug
Solution
Tank
Drain
Hose
Summary of Contents for Z210
