MACHINE OPERATION
5. Adjust the flow rate of the cleaning solution with lever. Moving the solution flow control lever
downward increases the flow rate and raising the lever decreases the flow rate. There should be
enough solution to wet the floor uniformly, but not so much that the water gets past the splash
guard. Remember that the correct solution quantity depends on the type of floor, the dirt level and
the scrubbing speed
6. Release and raise the brush base lift lever to lower the brush base
7. Lower the squeegee using the squeegee lift lever
8.
MACHINE MOTION
This machine is equipped with traction wheel propulsion. To move machine forward, rock
traction directional switch forward and depress the handle switch lever. Adjust the forward speed
with the traction drive speed control knob. During the first few yards of operation, check that the
quantity of the cleaning solution is sufficient to wet the floor and that the squeegee dries the floor
surface. To move machine in reverse, lift the squeegee assembly with the squeegee lift lever and
rock traction directional switch rearward and depress the handle switch lever
WARNING!
Always lift the squeegee when moving backwards
9. SCRUBBING
Depress the handle switch lever. The scrub brush will begin to rotate and solution will begin to
flow. During the first few yards of operation, check that the quantity of the cleaning solution is
sufficient to wet the floor and that the squeegee dries the floor surface
WARNING!
Always lift the squeegee when moving backwards
Summary of Contents for Z210T
Page 34: ...34 WIRING DIAGRAM DRAWING 10...
