INSTALLATION INSTRUCTIONS
These instructions are written for qualified technicians. They serve as a
guide for installation, adjustment and maintenance in accordance with
existing laws and standards. All the procedures must be duly completed
before the appliance is connected with electricity.
1. When installing the cooker, maintain the minimum distance from
wall and ceiling, otherwise the walls may be over heated that
could cause fire. (refer to Fig 1)
2. If the distance between the walls and periphery of the burner is
less than the specified ones, the walls must be protected with a
non-combustible coating.
3. Before installing the appliance, check that the location provides
the required distance from combustible materials and of necessary
provide protection to adjacent surfaces as required. Make
provision for the gas supply to be connected to the location.
4. Cut the opening in the bench top in accordance to the dimension
shown in Fig 2.
5. Remove the hob from the carton.
6. Install the hob into the cut-out opening.
7. Connect the gas supply by using an iron or copper pipe, starting
from the outlet Y (Fig 3). The sealing washer must be fitted
between the outlet Y and copper pipe.
8. Insert the Ø9.5mm gas hose to the gas inlet and tighten with hose
clamp (Gas valve and gas inlet – 2 positions). See Fig 4.
9. Fix the dry battery underneath the cooker into the battery
compartment as shown below. Battery polarity’s position must
place in accordance to the positive & negative placement in the
battery compartment. See Fig 5
10. Once the gas hose is connected, an inspection to check for any
gas leakage must be done. Turn the gas on and check around all
the joints using a soap solution.
11. Test the appliance: Press the control knob and turn to full flame
setting to activate the electric igniter. The burner will be ignited.
Adjust control knob to the desired setting. On initial usage you
may have to repeat this ignition function several times to allow air
flush out from the gas supply system. No adjustment should be
necessary. If any problems occur refer to the troubleshooting
chart.
12. When the sound of ignition spark becomes weaker or the flame
easily put off during ignition time, replace with new battery. Always
reserve space underneath the cooker for changing the battery.
13. If there is no gas valve or gas pipe at the installation area or the
pipe’s diameter is not suitable, then a new gas pipe must be
installed or changed the existing one. Installation or change of
new gas valve must be done by authorized contractor.
