HOB WITH SAFETY DEVICE
1. Safety device is equipped with automatic shut off gadget. When the flame is extinguished by
the wind or overflow of food, this device will automatically cut off the gas supply for your
safety.
2. Turning the knob clockwise to “off” position, a click sound will be heard, the gas supply is shut
off and the flame will extinguish.
When the burner is fitted with a flame supervision device, the device shall not operate for
more than 15 seconds during ignition. If after 15 seconds the burner still does not lit, stop
operating and open the compartment door of the cabinet and wait at least one minute before
attempting to ignite the burner again.
TROUBLESHOOTING
FAULT
CAUSES
REMEDY
Burner does not ignite
1. Air in gas line
2. Blockage in line
3. Igniter not sparking
4. Battery runs out
5. Battery
is
installed
wrongly
6. Gas supply valve turned
off
7. Burner cap’s holes stuck
8. Burner
cap
is
fitted
wrongly and the ignition
cannot reach to light up
1. Clean the gas line
2. Trace back and clear
3. Check the lead and electrode gap
4. Change a new battery
5. Reinstall the battery properly
6. Turn on gas supply valve
7. Clean and dry the burner cap
8. Place the burner cap back to its
proper place to reach the igniter
Fire flow back to injector
1. Excessive dirt at the
burner
2. Excessive gas pressure
1. Remove and clean burner
2. Check gas regulator pressure and
adjust it if necessary
Igniter not sparking
1. Battery runs flat
2. Excess electrode gap
3. Igniter
connection
is
loose
4. Burner cap is blocked by
aluminum foil
1. Replace a new battery
2. Check the gap, adjust the igniter to
fall within 4-5mm from the burner
cap.
3. Check connections to igniter, replace
it if it is faulty
4. Remove the aluminum foil
Flame cannot be held
1. Incorrect turning of gas
control knob
1. Press and turn the gas control knob
anti-clockwise until a ‘click’ sound is
heard. Hold for a few seconds until flame
is ignited
Yellow flame
1. Accumulated grease and
dirt on burner cap (head)
1. Wash burner cap (head) in warm water
with detergent. Leave it on dry and then
place it back
Low heat or overheating 1. Incorrect size cooking
utensil being used
1. Use pans with the right diameter to fit
the burner
