2
Packard Bell Vibe 500 Disassembly Manual
Overview
This document contains step-by-step disassembly instructions for the Vibe 500 MP3 player. The
instructions are illustrated where necessary with images of the part that is being removed or
disassembled. Furthermore, the screws that are removed are shown next to the image of the parts
themselves.
Packard Bell reserves the right to make changes to the Vibe 500 MP3 player without notice.
Technician Notes
Only technicians authorized by NEC Computers International B.V. should attempt to repair this
equipment. All troubleshooting and repair procedures are detailed to allow only subassembly/module
level repair. Because of the complexity of the individual boards and subassemblies, no one should
attempt to make repairs at the component level or to make modifications to any printed wiring board.
Improper repairs can create a safety hazard. Any indication of component replacement or printed wiring
board modifications may void any warranty or exchange allowances.
Disassembly Instructions
When disassembling the system unit, follow these general rules:
n
Turn off the power and disconnect all cables and peripherals.
n
Label all removed connectors. Note where the connector goes and in what position it was
installed.
n
Do not disassemble the system into parts that are smaller than those specified in the
instructions.
Reassembly Instructions
Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and screws are
returned to their proper positions. Check that no tools or any loose parts have been left inside the player.
Check that everything is properly installed and tightened.
Required Tools
All disassembly procedures can be performed using the following tools:
n
Philips (#1 bit) screwdriver.
n
Small flat-bladed screwdriver or a small coin.
