BPG510 User Interface Guide
About your Broadband Phone Gateway (BPG510)
FRONT
(1) Power – The Power light is solid green when the power is on.
(2) Service – The Service light is solid green when you are authenticated with
Packet8
(3) WAN – The WAN light is green to indicate that your modem is connected
properly to the Internet. It blinks rapidly when information is being sent over the
port between BPG510 and the modem.
(4) LAN – The LAN light is green when a PC or other networking device is
connected to the BPG510 with a network cable.
(5) Line – The Line light is green when you go off hook to indicate that your BPG510
is ready to make a call.
(6) Message – The Message light is green when you have a message waiting in
your mailbox.
REAR
(picture)
(1) Power Jack – Connect the included power cord to this jack.
(2) Reset Switch – The “Reset” button is used in rare cases when the BPG510 may
function improperly. Resetting the BPG510 will restore the BPG510’s normal
operation while maintaining the programmed settings. We recommend you
consult a Packet8 customer service representative before using this button.
(3) WAN – The WAN port is for connection to your cable or DSL modem or to
connect to your existing router.
(4) LAN – The LAN port is for connection to your computer or other networking
device.
© 8x8 Inc., 2005
Page 3 of 27
(5) Line – The Line port is for connection to your telephone handset. Use the
telephone cable to connect the telephone to this port.
