THIS PRODUCT IS SUITABLE FOR INDOOR USE ONLY.
BATTERY SAFETY WARNINGS
Never try to short-circuit the battery terminals.
DO not charge non-rechargeable batteries.
Batteries are to be inserted with the correct polarity as indicated inside the battery compartment.
CAUTION: danger of explosion if battery is incorrectly replaced.
Do not mix batteries of different types.
Remove batteries during long period of non-use.
Always remove exhausted batteries from the product.
Dispose batteries safely. DO not dispose this product or any batteries in a fire.
WARNING: The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
BATTERY REPLACEMENT
Pull out the battery compartment cover at the base of the remote control.(see page 1)
Replace the battery with the same type and take care the correct polarity as indicated inside the battery
compartment.
Place back the battery compartment cover.
The tree or lights do not respon to your remote , it’s time for an adult to change the batteries
Clean only with dry cloth
For indoor use only, keep away from rain and water
DO NOT block any ventilation opening
WARNING: Contains small parts. Risk of suffocation. Keep the remote control out of the reach of children.
BULB REPLACEMENTE INSTRUCTIONS
1. Unplug light string from power source.
2. Pull up on the bulb lock unlatching the bulb from the bulb socket. Gently pull the bulb straight out ( Fig.1 ) .
3. Before inderting the new bulb into socket, make sure that the two wires on either side of the bul base are
staight up and flush with the base.
4. Carefully insert new bul into socket and push down bulb lock until it snaps into place ( Fig. 2 ).
Fig.1
Fig.2
ALWAYS UNPLUG FROM THE MAINS SUPPLY BEFORE CHANGING A BLUG. DO not remove or insert
lamps while the chains are connected supply.
Replacement lamps must be of the same type, rated voltage and wattage as those delivered originally or of
a type specified by the manufacturer.
Ensure all lamp holders fitted with a lamp.
DO NOT attempt to connect any lighting chains other than the one supplied. It may overload the product and
adaptor and result to risk of fire.
