INSTALLATION GUIDE
FSTA/2 Series LED Roadway Lights
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2023 PacLights All Rights Reserved
Page 1 of 2
Need help? (800) 988 -6386 Email: CS@PacLights.com Website: www.PacLights.com
PL_INST_FSTA/2_v0
FSTA/2 INITIAL SET-UP
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
•
Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
•
To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
•
For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
FIG. 1
OPTIONAL PHOTOCONTROL SENSOR
FIG. 2
FSTA/2-L/M/H
FSTA/2-X
Install the Short-Cap on the Receptacle correctly by pressing down and
twisting CW (Fig. 1). Note: If Photocontrol Sensor is provided see the
following for instructions.
Connect the ACL and the ACN from the FSTA/2 fi xture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
FSTA/2 DRIVER
GRAY (-)
PINK (+)
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
WIRING DIAGRAM
DIM
INPUT
SHORT-CAP
There are two types of Twist-Lock Photocontrol Sensors available. One
of the Photocontrol Sensors has a Dusk to Dawn functionality. Both
Photocontrol Sensors can be easily installed on all FSTA/2 fi xtures as shown
below. Install the Photocontrol Sensor on the Receptacle correctly by
pressing down and twisting CW (Fig. 2). Note: If the Photocontrol Sensor
is not included the following step can be skipped. If the Photocontrol
Sensor is included prior to fi eld installation, Initial Set-Up can be skipped.
PHOTOCONTROL
SENSOR
FSTA/2 FIXTURE
RECEPTACLE
