User’s Manual
32
9.
Move to
Use Callback
, and check the box to enable the callback function.
NOTE:
When using the callback function with modem connections, check the
Use Modem
box and then select
the installed modem to use. Also, the dial-up server should be running on the target server to be notified. See
Appendix 4 – Network Sestup (Modem)
for details.
10.
Move to
Center
, and enter the IP address of each server. A maximum of three servers can be set.
NOTE:
When selecting the
Use Modem
, enter the telephone number of the target server instead of the IP
address.
11.
Move to
Retry Counts
, and enter the number of times you would like the DVR to try contacting the server if the
connection fails.
12.
Move to
When
, and select the target event. The DVR will call when the selected events occur. Multiple
selections are available. You can save your changes by clicking the
OK
button. Selecting
Cancel
exits the
Set
up Callback
dialog box without saving the changes.
NOTE:
Callback messages will be displayed on the system status window of the target server. They include
event type, event detection time, and system location entered during the
System
setup.
13.
Click the
Set up
Email…
, and set up the e-mail notification. Each event can be set individually for e-mail
notification. Select the Event tab to set up.
