page 10
Paddle Palace A32W PRO Robot
User Manual
Trouble-Shooting
Robot doesn’t work
Robot works but does not release the balls
Speed and Frequency cannot be adjusted
The plug is not connected properly to the electrical outlet.
Check the plug connected to the electrical outlet
The key on the control box is not pressed.
Press the switch until the number displays
The control box doesn’t work
Replace control box
The poke bar in ball container is loose
Fasten the poke bar
The ball duct is jammed by foreign object
Clear away the foreign object (see page 9)
The amount of balls in the container are not enough
The amount should be 50 to 100 balls
It takes time to transport the balls from container
Wait for a while
to shooting head
The robot doesn’t work due to the improper operation of
Turn power off. Wait 5 seconds, then start up again
control box
The cable connecting to motor is loose
Connect it with the original method
Rechargeable battery has run out [if you are using a battery]
Recharge the battery until it reaches full charge
FAILURE
CAUSE
SOLUTION
General Warnings
1. Please read the instruction manual carefully before using the robot, and follow the operation instructions.
2. Use care when connecting and disconnecting the ball collection net.
3. When the robot is operating, please do not open the movable door and touch the top and bottom wheel. Do not
touch the poke bar.
4. Turn the power switch off and unplug the robot after use.
QUICK START - Step-By-Step Instructions for Setting Up Robot
1.
Set the
FREQUENCY
- Press (+) to increase. Press (-) to decrease.
2.
Set the
HEAD ANGLE (LOOP)
.
3.
Set the type of
SPIN
.
4.
Set the
THROW WHEEL SPIN
(amount of speed and spin).
5.
Press the
START/PAUSE
button to start the Robot.
