page 9
Paddle Palace A32W PRO Robot
User Manual
How to Maintain Your New Robot
P
ELECTRONICS:
The robot’s electric components are located in the
machine’s circuit board and the control box. Therefore, you should
be careful to avoid dropping either component or avoid any activity
that would cause damage to the internal electronic units of one or
both of these components.
P
MECHANICS:
The robot’s mechanical components are located in
the mechanisms that produce the ball service and delivery. Special
attention should be paid so that no foreign objects are put into the
ball container. Foreign objects will block the robot’s delivery wheel
and result in damage to the robot. If a foreign object does enter the
ball container, first, turn off the power, then loosen Knob 1 and Knob
2
(A)
. Open the movable door and remove the transparent guard
plate
(B)
. After removing the foreign object or objects, replace the
guard plate and close the door and tighten Knobs 1 and 2.
Knob 2
Knob 1
Q
Loosen
A
B
Loosen
Using screwdriver, loosen the 4
screws (indicated by arrows).
Poke Bar
C
D
E
P
POKE BAR:
When the poke bar
(C)
inside the ball container has
worked for a long time, it should be checked for loose screws so as
to prevent any trouble that would lead to an irregular ball delivery.
This should prevent any blockage issue inside the robot.
P
FRICTION WHEELS:
Under normal operation, and after long use,
the top and bottom friction wheels may become dirty. To ensure a
quality serve, please clean the wheels often with a wet towel
(D)
.
Always turn off the robot’s power before cleaning. To avoid doing
damage to the internal parts of the robot do not use force to move
the shooting head.
The friction wheels are able to work for 5,000 hours or longer
before they need to be replaced. When performing the replacement,
power off the robot, remove the
protective cover and remove the
screws from the friction wheels
with a screwdriver
(E) and (F)
.
Turn clockwise to tighten and turn
counterclockwise to loosen. After
replacing the wheels, replace the
screws properly and with care.
F
During an operation or transportation, protect the robot against any strong impact or oscillation.
