page 10
Paddle Palace S4W Robot
User Manual
Shooting
Head 1
Setting Double Head Serve
The control box automatically stores the current settings when the robot is turned off and will start with those
settings next time the robot used.
1. Set the
Total Number of Balls
.
2. Set the
Frequency
.
3. Set the
Head Angle
(loop) for Shooting Heads 1 and 2.
4. Set the type of
Spin
, rotate the Shooting Heads until the spin indicator points
to the type of spin wanted. Set both heads.
5. Set the
Throw Wheel Speeds
(amount of speed and spin) for
Shooting Heads 1 and 2
6. Select the
Landing Spot Location Sequence
you want to use. You have three
options: Random, Pre-Programmed (various), or you can program your own
landing spot sequence. If you set
Random
in step 6, you are done.
Press the
Start/Pause
to start robot.
7. If you set
Various,
use the
Up
or
Down
buttons to choose one of the
30 sequences (See page 13).
8. If you chose to program your own Landing Spot Sequence in Step 6, set the
ball counter for Head 1.
Shooting
Head 2
Total Number
of Balls
Landing Spot
Landing Spot Locations
Sequences in
Random
9. Push
Landing Spot
button
(IMPORTANT! PRESS LANDING SPOT
BUTTON
ONLY ONCE
WHEN SETTING BOTH HEADS)
10. Set landing spot locations for Head 1.
11. Set ball counter for Head 2
12. Set landing spot locations for Head 2
13. Press
Start/Pause
button to start robot.
IMPORTANT! The ball counters for both Head 1 and Head 2 must match
the number of landing spot locations set for Head 1 and Head 2. (If Head 1
is set for 3 balls then 3 landing spot locations must be selected. If Head
2 is set for 5 balls then 5 landing spot locations must be selected.)
Setting Single Head Serve
1. Set the
Ball Counter
of one shooting head to infinity.
Press and hold the (+) button until a dash appears.
2. Set the
Frequency
press (+) to increase (-) to decrease.
3. Set the
Head Angle
(Loop) - illustration below
4. Set the type of
Spin
(spin indication) - See page 5
5. Set the
Throw Wheel Speed
(amount of speed and spin)
6. Set the
Landing Spot Locations
.
7. Press
Start/Pause
button to start robot
When changing the loop of the serve, loosen the Loop Lock Knob before
adjusting the Loop Modulation Wheel.
When achieving your desired loop, lock the knob.
High curve = landing spot long
Low curve = landing spot short
Ball
Counter
Frequency
IMPORTANT NOTE:
The robot will serve Head 1’s entire sequence first, then serve head two’s entire sequence. When
Head 2’s sequence has been completed, the robot will repeat the serving order beginning with Head 1, followed by Head 2.