Page 2 of 2
Rev. A
How to install your
T@G Clamshell Tent
by PahaQue
1.
First, locate the keder rails and remove adhesive covering. Placement
of keder rails should be 3” above hatch hinge, but below the antenna.
(Surface must be clean and dry. Use rubbing alcohol or window cleaner.)
Line up keder rails so that they form 1 continuous channel across trailer
roof. Affix and press firmly. It’s best if keder rails are left overnight to
fully set before attaching tent.
2. Locate corner protectors and affix them to corners of clamshell
hatch as pictured. This is to protect the roof of the tent from the
sharp corners of the hatch.
2.
Next, insert keder cord on tent body into keder rail.
Photo A
3.
Next, locate and assemble both roof poles and insert into roof
sleeves. Beginning at the front, right side of tent (opposite the
trailer) Make sure leading edge of pole is fully seated into roof
pole sleeve. Next, insert trailing end of roof pole into plastic
elbow connector. Repeat for other roof pole.
4.
Next, locate and assemble both aluminum corner poles. Insert
open ends into elbow connectors from Step 3 and pegs into
grommets near ground. Photo D
5.
Exact placement of the Velcro on the floor of the trailer for the skirt
varies and is at the users’ discretion. The skirt shouldn’t be too tight to
that it doesn’t pull of the Velcro when standing near it. Remove
adhesive backing from Velcro and affix to trailer floor as shown.
6. Next, secure “C” clips to corner poles. Photo E
7. Locate and assemble lateral Fiberglass roof pole. This inserts
into the 2 webbing pockets in the ceiling of tent near the edge of
the Clamshell hatch. Insert pole into pocket with Velcro opening
last. Photo F.
8. Lastly, using the included ground stakes, secure tent to
ground using all ground stake-down points along outside bottom
edge of tent.
!CAUTION!
The effects of wind and rain on the Tent are unpredictable. Damage to the trailer and/or Tent may result. Please remove the
Tent in heavy wind or rain. Damage due to weather is not covered by your warranty.
