Pain Relief Essentials Rhythm Touch, Instruction Manual

Assembly of Rhythm Touch 

Power the unit by inserting 2 AAA batteries (included) in the battery compartment.  This 
is located at the back bottom of the Rhythm Touch.  Connect the lead wire cords to gel 
pads by inserting the thin metal end of the lead wire into the gel pad slots.  Connect the 
lead wire cords to the base unit by inserting the thick plug end of the lead wire into the 
base unit sockets. Turn the device off before installing or changing batteries. 
 
Please Note: 
If the unit does not operate, consult the troubleshooting section of this instruction manual. 
Always turn the unit off before replacing the batteries. 
 
How to Use the Pads 
The Rhythm Touch pads are designed to stimulate muscles of large body areas.  Pads are 
ideal for use on the shoulders, back, stomach, legs, arms and other areas of the body. 
 
To use the pads connect the pads to the Rhythm Touch base unit, as described in the 
Setup Procedures in this manual.  Adjust the power level dial to the weakest setting (MIN 
or "0").  This dial is located on the right-hand side of the base unit.  Remove the vinyl 
pad protectors, and stick the pads to the protective plastic holder during operation.  

Do 

not stick the pads together or on paper

.  Before attaching pads, wipe off all sweat, oil and 

dirt from the location on the body where they will be placed.  Place the pads in the 
desired location.  Always attach two pads on the body, but do not overlap them. Turn the 
strength dial to “0” before moving pads to another location. Turn the strength dial to “0” 
before selecting different massage key.  
 

 Please refer to the Chart of Reflex Points and Safety Instructions information in this 

manual. 
 

Assembly Continued: 

Turn the base unit on by pressing the on/off button, the top left front panel.  The Rhythm 
Touch will automatically shut off after 15 minutes.  Adjust the strength level dial to the 
strength you prefer, from weak to strong.  Select the mode of operation you prefer. 
Choices are located on the front panel and include:  

1.

Tap, 2. Vibrating, 3. Massage, 4. Auto Mode. 

Turn the strength dial to “0” or “MIN” before moving pads to another location of the 
body. 
 

Please Note: 

Do not put the pads in water. 
Do not use the pads if they are wet. 
The durability of the pads depends on how they are cared for and how often they are 
used.