8.3
ENGINE SECTION CONNECTIONS
8.3.1 Route the wiper motor, coil, choke, temp sender, oil sender, starter, alternator
and a/c compressor wires across the firewall to the wiper motor and to the
engine.
NOTE: Included in the kit are 6 large harness securing clamps for the firewall and inner
fender routing and 2 small clamp for headlight crossover wires.
8.3.2 Cut wiper motor wires to length, terminate and connect wires as shown in Figure
8.12
11
8.3.3
Locate the maxi fuse holder and mount it to the passenger side inner fender
Figure 8.11 Wiper Motor and Engine Wire Routing
NOT
USED
YELLOW
LT.BLUE
BLACK
YELLOW BLUE
Figure 8.12 Wiper Motor Connections
Summary of Contents for 20110
Page 29: ...NOTES 24...
