panel as shown in figure 8.13. Take the starter Red wire (916) and route it to the
maxi fuse holder. Cut the wire, crimp on a ring terminal and connect it to a fuse
holder terminal. Take the remaining wire that was cut off and crimp on a ring
terminal, connect it to the other side of the fuse holder. Take the other end and
route it to the starter solenoid and connect it to the large battery terminal.
NOTE: If using an alternator larger than 65 Amps, you will need to review the
instructions in the PP-662 ALTERNATOR WIRE KIT (supplied in bag in with this
harness) before you make any maxi fuse or starter connections.
CAUTION:
TO PROTECT THE ENTIRE SYSTEM THE MAXI FUSE MUST BE
INSTALLED AS INSTRUCTED.
8.3.4
Route and connect the starter, coil, oil sender, choke, temp sender, a/c
compressor and alternator wires.
12
Figure 8.14 Electric Choke Connections
Figure 8.13 Maxi Fuse
Summary of Contents for 20110
Page 29: ...NOTES 24...
