5.
If the Coil you are using is not internally resisted, a ballast resistor will be required. If a coil is
not internally resisted and a ballast resistor is not used, the coil will overheat within a few
minutes to the point that it will no longer work. A ballast resistor can be obtained at your
local parts store using part number RU11.
The wiper switch connector is no longer available. We have terminated the wiper switch
wires with the correct terminals so that your original connector can be re-used.
Remove the old terminals by using a small screwdriver or paperclip in the slot at the top
of the terminal closest to the center of the connector. Push the release tang (pin) in
and pull the wire out from the opposite side.
Re-install the wires in the same order by color code configuration that was removed.
Diagram 1 Wiper Switch Connector
23
Summary of Contents for 20110
Page 29: ...NOTES 24...
