1
2501 Ludelle Street
Fort Worth, Texas 76105
817-244-6212 Phone • 817-244-4024 Fax
888-350-6588 Sales • 800-423-9696 Tech
E-mail: painless@painlessperformance.com
Web:
www.painlessperformance.com
30115
DUAL ACTIVATION FAN RELAY WITH 185
o
ON 175
o
OFF
THERMOSTAT INSTALLATION INSTRUCTIONS
This electric fan relay kit has a capacity of 30 Amps and will operate a single or dual fan setup.
The relay will activate the electric fan if the thermostat reaches 200 degrees Fahrenheit or if the
A/C compressor clutch is engaged.
1.
Mount the relay under the hood in a convenient location as close to the fan as
possible. Use the ¾” self tapping hex screw to mount the relay base. The black wire
with the ring terminal preinstalled will also need to be grounded with this terminal.
Make sure the area you mount this provides a clean ground for the black wire.
2.
Install thermostat into a
water jacket in the head or
intake manifold. Unroll the
PINK wire from the parts
kit. Strip ¼” of insulation
from the copper on one end.
Crimp one of the female
spade connectors onto this
wire. Push the spade
connector onto one of the
male spades on the
thermostat. Route the PINK
wire from the thermostat to a
12 Volt ignition hot source.
Cut it to length and use the
blue Posi-tap to make the
connection. To the right is
an illustration of how to use
a Posi-tap.
3.
Route the GRAY/WHITE wire from the relay to the thermostat. Strip ¼” of
insulation from the copper and crimp on the other female spade terminal. Push this
onto the other male spade terminal on the thermostat.
Summary of Contents for 30115
Page 3: ...3...
