2
CONTENTS OF THE PAINLESS KIT
Refer to the
Contents Figure
(below)
to take inventory. See that you have
everything you’re intended to have in this kit. If you find that anything is missing or
damaged, please contact the dealer where you obtained the kit or Painless Performance
at (800) 423-9696.
The Painless Off-Road toggle Switch Kit should contain the following:
(1) 4 or 6-Switch Customizable Switch Panel w/ (1) label sheet
(1) Foam Liner
(5 or 7) Toggle Switches
o
(3 or 5) On-Off
o
(1) On-Off-On
o
(1) Off- Momentary On
(4 or 6) Toggle Switch Boots
(1) Ignition Switch & (1) Ignition Switch Nut w/ Boot
(4 or 6) Circuit Breakers
o
(1) 10 amp (50332 only)
o
(1 or 2) 15 amp
o
(3) 20 amp
(4 or 6) Clear Circuit Breaker Boot
Hardware: (1) 10-12 ga.
3
∕
8
” Ring Terminal, (7 or 9) 14-16 ga. #10 ring
Terminals, & (6) 8x12 screws
(1) Diode Assembly
(1) Ign. Sw. to Circuit Breaker Power Wire Assembly
(1) Power Wire
(1) Purple Starter Solenoid Wire
(4 or 6) Red Jumper Wires
(5 or 7) Pre-Terminated Control Wires.
Zip-ties
