Installation
150-458-100-05
6
February 23, 2000
HRE-458 List 1, List 1B, and List 2
I
NSTALLATION
This section describes the setup and installation of the HRE-458.
U
NPACKING
AND
I
NSPECTING
Y
OUR
S
HIPMENT
When you receive the equipment, inspect it for signs of damage. If damage has occurred, immediately report the
extent of damage to the transportation company and to ADC (see
“Appendix C - Product Support” on page 38
for
more information).
Your shipment should consist of:
•
One HRE-458
•
HiGain Remote Therm-O-Nator Enclosure HRE-458 List 1
, List 1B,
and List 2 User Manual
Before installing the HRE-458, unpack and inspect it for missing components and physical damage that may have
occurred during shipping. To unpack the enclosure:
1
Remove the HRE-458 from its shipping carton.
2
Perform an inventory to verify that all equipment listed on the packing list is present.
3
Inspect the enclosure for shipping damage.
4
Check the card cage for any sign of breakage.
5
Check the O-ring for any sign of damage.
6
Find and loosen the retaining screws at the rear base of the card cage.
7
Tilt the card cage on its hinge.
8
Lower the card cage to its level position and tighten the screws to lock it in position. ADC recommends
always keeping the card cage in a level, locked position.
9
Report any damage to the carrier immediately.
If you must store the equipment for a prolonged period of time, store it in the container shipped
with your equipment.