950-770-100
March 14, 1997
Revision 01
PG-Plus PRL-770
PairGain Engineering-Plant Series
Page 9
2
Use a pencil to punch a small hole in the bottom of the rubber grommet on the left-hand bottom
side of the PRL-770 RT enclosure (Figure 7).
Figure 7. Attaching the Frame-Ground Wire
3
Insert the frame-ground wire into the PRL-770 RT enclosure through the pencil hole made in
step 1. A 10 AWG copper frame ground wire is recommended.
4
Loosen and remove from the ground-binding post the top nut and three flat washers.
5
Loop the frame-ground wire around the ground-binding post, then replace and tighten the
hardware removed in step 4, in reverse order.
Summary of Contents for PRL-770
Page 18: ......
