Revision 01
March 14, 1997
950-770-100
Page 10
PairGain Engineering-Plant Series
PG-Plus PRL-770
5.6
Attach the HDSL Tip and Ring Wires:
Always treat the HDSL pair as if it were live with high voltage present. If you
have not shorted the HDSL Tip and Ring conductors as described in section 5.2,
do not connect the HDSL Tip and Ring wires. Otherwise you may receive a
severe electrical shock.
1
Use a pencil to punch a second small hole in the bottom of the rubber grommet on the left-hand
bottom side of the PRL-770 RT enclosure.
2
Insert the HDSL Tip and Ring wires into the pencil hole made in step 1.
3
Loosen only the top nut on the Tip and Ring gas tube protection binding posts (Figure 8).
4
Insert and then loop in a clockwise direction the HDSL Tip and Ring wires between the top two
washers on the appropriate binding post, then tighten the nut you loosened in step 3.
Figure 8. Attaching the HDSL Tip and Ring Wires
Summary of Contents for PRL-770
Page 18: ......
